| |
| Wear Plates |
| Series G pump casings may be supplied fitted with hardened,
replaceable wear plates (standard on sludge pumps). The wear plates
can be replaced with minimal pump dismantling and without removal of
pump from service. |
|
|
| |
| Pumped Media Seals |
|
The optimum primary seal can be chosen to match the pumped media
and duty conditions. Single or double mechanical seals include flushed
or aseptic variants. For arduous duties hard faced seal materials such as
tungsten carbide or silicon carbide can be used. A wide variety of commercially
available mechanical seal options including single and double
cartridge seals are available for sludge and other difficult applications.
Packed glands offer a simple, low cost, and easy to maintain controlled
leakage sealing arrangement.
Pumped media wetted elastomers are EPDM, NBR, FPM all FDA
conforming or PTFE for chemical applications.
|
|
|
| |
| Connections |
| Pump casings are supplied with integral cast flanged inlet and outlet
connections to all major standards including ASA/ANSI150,
BS4504/DIN2533, BS10E and more. |
|
|
| |
| Rotor Materials |
For increased abrasion resistance pumps may be supplied with NBR
covered (models G7-0550-H07 and
G8-0745-H10 only) or urethane rotors. The urethane
rotors can be supplied slotted, providing grit channels to improve
rotor life. |
|
|
| |
| Surface Finish & Coatings |
| For abrasive applications the pumphead and rotors may be supplied
with a tungsten carbide coating or other surface hardening treatment to
increase wear resistance. |
|
|
| |
| Increased Pressure Rating |
|
Alternative higher strength shaft materials will enhance pressure ratings.
- 145 psi for pump model G7-0550-H07
- 100 psi for pump model G8-1149-H03
|
|
|
| |
| Motorized Pump Units |
| Series G pumps may be supplied fully motorized with fixed or variable speed
drives including appropriate control systems if required, mounted on
either mild steel or stainless steel baseplates. In addition to electric
motor drives, hydraulic, pneumatic, diesel or gasoline powered prime
movers can be fitted. |
|
|
| |
|
